Vinand

user Occupation hasn't been added

city Company hasn't been added


  • Active Antenna with Gain

  • Created: Aug 08, 2017

    • view146
    • comment0
    • bookmark0
    • fork0

Description

No description available.

Summary

The signal booster, built around a few transistors and support components, offers an RF gain of about 12 to 18 dB (from about 100 kHz to over 30 MHz).

The RF signal is direct-coupled from Q1's source terminal to the base of Q2, which is configured as a voltage amplifier. The output of Q2 is then direct-coupled to the base of Q3 (configured as an emitter-follower amplifier). Transistor Q3 is used to match and isolate the gain stage from the receiver's RF-input circuitry.

Inductor L1 is used to keep any power source noise from reaching the FET (Q1) and any value of RF choke from 0.5 to 2.5 mH will do. The value of R2 sets the Q2 bias at about 2 V. If the voltage is less than 2 V, increase the value of R2 to 1.5 kΩ. To go below 100 kHz (to the bottom of the RF spectrum), increase the value of C1 to 0.002 µF. The antenna is a short pull-up type (42" to 86" long).

Details


Components:

  • No components added

Tags:

Application:

  • No project application added

Type:

  • No project type added