Frank Pacquiao

user Test Engineer

city ISI


  • Electronic Time Delay

  • Created: Dec 03, 2014

    • view1352
    • comment0
    • bookmark1
    • fork0

Description

No description available.

Summary

The time delay, T, in seconds is: T = 1.1 x C1 x (R1 and R2). The resistances are in megohms and capacitances in microfarads. The sum of R1 and R2 should not be less than 1000 Ω nor higher than 20 MΩ. Pressing S1 starts the timing cycle. A low-going pulse, instead of S1 can be used to initiate the timing cycle. With the values shown and allowing for the tolerances of the 200-µF capacitor, the delay will range from 4 minutes and 50 seconds to 7 minutes and 26 seconds. The output terminal, pin 3, of 555, is normally low and switches high during the timing cycle. The output can either sink or source currents up to 200 mA. Therefore, a load such as a relay coil can be connected between pin 3 and Vcc or between pin 3 and ground, depending on circuit requirements. When the relay is connected between pin 3 and ground, it is normally de-energized so it is energized only during the timing cycle. Connecting the relay to ground will save power and allow the IC to run cool.

Details


Components:

  • No components added

Tags:

Application:

  • No project application added

Type:

  • No project type added

Document Support:

- None